Currently, only one @var{vid}, @var{pid} pair may be given, e.g. for
Altera USB-Blaster (default):
@example
-ft2232_vid_pid 0x09FB 0x6001
+usb_blaster_vid_pid 0x09FB 0x6001
@end example
The following VID/PID is for Kolja Waschk's USB JTAG:
@example
-ft2232_vid_pid 0x16C0 0x06AD
+usb_blaster_vid_pid 0x16C0 0x06AD
@end example
@end deffn
debug handler are either (0x800 - 0x1fef800) or (0xfe000800 -
0xfffff800). The default value is 0xfe000800.
+XScale has resources to support two hardware breakpoints and two
+watchpoints. However, the following restrictions on watchpoint
+functionality apply: (1) the value and mask arguments to the @code{wp}
+command are not supported, (2) the watchpoint length must be a
+power of two and not less than four, and can not be greater than the
+watchpoint address, and (3) a watchpoint with a length greater than
+four consumes all the watchpoint hardware resources. This means that
+at any one time, you can have enabled either two watchpoints with a
+length of four, or one watchpoint with a length greater than four.
These commands are available to XScale based CPUs,
which are implementations of the ARMv5TE architecture.
This finishes by listing the current vector catch configuration.
@end deffn
+@deffn Command {cortex_m3 reset_config} (@option{srst}|@option{sysresetreq}|@option{vectreset})
+Control reset handling. The default @option{srst} is to use srst if fitted,
+otherwise fallback to @option{vectreset}.
+@itemize @minus
+@item @option{srst} use hardware srst if fitted otherwise fallback to @option{vectreset}.
+@item @option{sysresetreq} use NVIC SYSRESETREQ to reset system.
+@item @option{vectreset} use NVIC VECTRESET to reset system.
+@end itemize
+Using @option{vectreset} is a safe option for all current Cortex-M3 cores.
+This however has the disadvantage of only resetting the core, all peripherals
+are uneffected. A solution would be to use a @code{reset-init} event handler to manually reset
+the peripherals.
+@xref{Target Events}.
+@end deffn
+
@anchor{Software Debug Messages and Tracing}
@section Software Debug Messages and Tracing
@cindex Linux-ARM DCC support