jtag/ft232r: switch to command 'adapter serial'

[openocd.git] / doc / openocd.texi

diff --git a/doc/openocd.texi b/doc/openocd.texi
index 4ce6e0426265c4470c5dcff9cd8641af154039b8..2891f3519c99a62c19cadc9d643e3490cd4a9c2b 100644 (file)
--- a/doc/openocd.texi
+++ b/doc/openocd.texi
@@ -2371,9 +2371,9 @@ This command is only available if your libusb1 is at least version 1.0.16.
 Specifies the @var{serial_string} of the adapter to use.
 If this command is not specified, serial strings are not checked.
 Only the following adapter drivers use the serial string from this command:
-cmsis_dap.
+cmsis_dap, ft232r.
 The following adapters have their own command to specify the serial string:
-ft232r, ftdi, hla, jlink, kitprog, presto, st-link, vsllink, xds110.
+ftdi, hla, jlink, kitprog, presto, st-link, vsllink, xds110.
 @end deffn
 
 @section Interface Drivers
@@ -2641,12 +2641,6 @@ The vendor ID and product ID of the adapter. If not specified, default
 0x0403:0x6001 is used.
 @end deffn
 
-@deffn {Config Command} {ft232r serial_desc} @var{serial}
-Specifies the @var{serial} of the adapter to use, in case the
-vendor provides unique IDs and more than one adapter is connected to
-the host. If not specified, serial numbers are not considered.
-@end deffn
-
 @deffn {Config Command} {ft232r jtag_nums} @var{tck} @var{tms} @var{tdi} @var{tdo}
 Set four JTAG GPIO numbers at once.
 If not specified, default 0 3 1 2 or TXD CTS RXD RTS is used.