@item @b{telnet_port} <@var{number}>
@cindex telnet_port
@*Port on which to listen for incoming telnet connections
-@item @b{telnet_async} <@var{enable/disable}>
-@cindex telnet_async
-@*Enable/disable asynchronous messages. Default off. Slows down debugging
-if enabled and telnet session is open while stepping.
@item @b{tcl_port} <@var{number}>
@cindex tcl_port
@*Port on which to listen for incoming TCL syntax. This port is intended as
@item @b{cortex_m3}
@item @b{feroceon}
@item @b{xscale}
+@item @b{arm11}
@item @b{mips_m4k}
@end itemize
If you want to use a target board that is not on this list, see Adding a new
-target board
+target board.
+The @option{target types} command can be used to get the list of targets supported from within openocd.
Endianess may be @option{little} or @option{big}.
Supported variants are @option{ixp42x}, @option{ixp45x}, @option{ixp46x},
@option{pxa250}, @option{pxa255}, @option{pxa26x}.
+@subsection arm11 options
+@cindex arm11 options
+
+@subsection mips_m4k options
+@cindex mips_m4k options
+Use variant @option{ejtag_srst} when debugging targets that
+do not provide a functional SRST line on the EJTAG connector.
+This causes openocd to instead use an EJTAG software reset command to reset the processor.
+You still need to enable @option{srst} on the reset configuration command to enable openocd hardware reset functionality.
+
@section Flash configuration
@cindex Flash configuration
@*Translate a virtual address to a physical address.
@end itemize
+@subsection CORTEX_M3 specific commands
+@cindex CORTEX_M3 specific commands
+
+@itemize @bullet
+@item @b{cortex_m3 maskisr} <@var{on}|@var{off}>
+@cindex cortex_m3 maskisr
+@*Enable masking (disabling) interrupts during target step/resume.
+@end itemize
+
@page
@section Debug commands
@cindex Debug commands