tcl: replace the deprecated commands with "adapter ..."

[openocd.git] / tcl / board / at91sam9g20-ek.cfg

diff --git a/tcl/board/at91sam9g20-ek.cfg b/tcl/board/at91sam9g20-ek.cfg
index 741d6018dc467e6feecf91cd1b711187e818dc15..773c8899a12c65e0069b01ba95a5d2a289753a47 100644 (file)
--- a/tcl/board/at91sam9g20-ek.cfg
+++ b/tcl/board/at91sam9g20-ek.cfg
@@ -19,7 +19,7 @@ set _FLASHTYPE nandflash_cs3
 
 reset_config srst_only
 
-adapter_nsrst_delay 200
+adapter srst delay 200
 jtag_ntrst_delay 200
 
 # If you don't want to execute built-in boot rom code (and there are good reasons at times not to do that) in the
@@ -54,7 +54,7 @@ proc at91sam9g20_reset_start { } {
        # jtag speed without causing GDB keep alive problem.
 
        arm7_9 fast_memory_access disable
-       adapter_khz 2                   ;# Slow-speed oscillator enabled at reset, so run jtag speed slow.
+       adapter speed 2                 ;# Slow-speed oscillator enabled at reset, so run jtag speed slow.
        halt                            ;# Make sure processor is halted, or error will result in following steps.
        wait_halt 10000
        mww 0xfffffd08 0xa5000501       ;# RSTC_MR : enable user reset.
@@ -103,7 +103,7 @@ proc at91sam9g20_reset_init { } {
 
        # Switch over to adaptive clocking.
 
-       adapter_khz 0
+       adapter speed 0
 
        # Enable faster DCC downloads and memory accesses.