stlink-dap: add 'cmd' to send arbitrary commands

[openocd.git] / tcl / board / topasa900.cfg

diff --git a/tcl/board/topasa900.cfg b/tcl/board/topasa900.cfg
index 065cd317aa61df29278caf5df2bc160fdf1842df..4fa63831bcc5a182815d7656c8fb82c3e3bb3d33 100644 (file)
--- a/tcl/board/topasa900.cfg
+++ b/tcl/board/topasa900.cfg
@@ -37,7 +37,7 @@ proc topasa900_init { } {
 # Init SDRAM
 #  _PMCDRV          = 0x00000071;
 #  //
-#  // Initialize SDRAM timing paramater
+#  // Initialize SDRAM timing parameter
 #  //
 #  _DMC_CAS_LATENCY = 0x00000006;
 #  _DMC_T_DQSS      = 0x00000000;
@@ -105,7 +105,7 @@ proc topasa900_init { } {
        mww 0xf4300004 0x00000000
 
        sleep 10
-#      adapter_khz NNNN
+#      adapter speed NNNN
 
 # remap off in case of IROM boot
        mww 0xf0000004 0x00000001
@@ -113,7 +113,7 @@ proc topasa900_init { } {
 }
 
 # comment the following out if usinf J-Link, it soes not support DCC
-arm7_9 dcc_downloads enable       # Enable faster DCC downloads
+arm7_9 dcc_downloads enable       ;# Enable faster DCC downloads
 
 
 #####################
@@ -123,4 +123,3 @@ arm7_9 dcc_downloads enable       # Enable faster DCC downloads
 #flash bank <name> cfi <base> <size> <chip width> <bus width> <target>
 set _FLASHNAME $_CHIPNAME.flash
 flash bank $_FLASHNAME cfi 0x20000000 0x1000000 2 2 $_TARGETNAME
-