tcl/board/8devices-lima.cfg

   1 # Product page:
   2 # https://www.8devices.com/products/lima
   3 #
   4 # Location of JTAG pins:
   5 # J2 GPIO0      JTAG TCK
   6 # J2 GPIO1      JTAG TDI
   7 # J2 GPIO2      JTAG TDO
   8 # J2 GPIO3      JTAG TMS
   9 # J2 RST        directly connected to RESET_L of the SoC and can be used as
  10 #               JTAG SRST. Note: this pin will also reset the debug engine.
  11 # J1 +3,3V      Can be use as JTAG Vref
  12 # J1 or J2 GND  Can be used for JTAG GND
  13 #
  14 # This board is powered from mini USB connecter which is also used
  15 # as USB to UART converted based on FTDI FT230XQ chip
  16
  17 source [find target/qualcomm_qca4531.cfg]
  18
  19 proc board_init { } {
  20         qca4531_ddr2_550_550_init
  21 }
  22
  23 $_TARGETNAME configure -event reset-init {
  24         board_init
  25 }
  26
  27 set ram_boot_address 0xa0000000
  28 $_TARGETNAME configure -work-area-phys 0xa1FFE000 -work-area-size 0x1000
  29
  30 flash bank flash0 ath79 0 0 0 0 $_TARGETNAME cs0