tcl/board/hammer.cfg

   1 # Target Configuration for the TinCanTools S3C2410 Based Hammer Module
   2 # http://www.tincantools.com
   3
   4 source [find target/samsung_s3c2410.cfg]
   5
   6 $_TARGETNAME configure -event reset-init {
   7         # Reset Script for the TinCanTools S3C2410 Based Hammer Module
   8         # http://www.tincantools.com
   9         #
  10         # Setup primary clocks and initialize the SDRAM
  11         mww 0x53000000 0x00000000
  12         mww 0x4a000008 0xffffffff
  13         mww 0x4a00000c 0x000007ff
  14         mww 0x4c000000 0x00ffffff
  15         mww 0x4c000014 0x00000003
  16         mww 0x4c000004 0x000a1031
  17         mww 0x48000000 0x11111122
  18         mww 0x48000004 0x00000700
  19         mww 0x48000008 0x00000700
  20         mww 0x4800000c 0x00000700
  21         mww 0x48000010 0x00000700
  22         mww 0x48000014 0x00000700
  23         mww 0x48000018 0x00000700
  24         mww 0x4800001c 0x00018005
  25         mww 0x48000020 0x00018005
  26         mww 0x48000024 0x009c0459
  27         mww 0x48000028 0x000000b2
  28         mww 0x4800002c 0x00000030
  29         mww 0x48000030 0x00000030
  30         flash probe 0
  31 }
  32
  33
  34 #flash configuration
  35 #flash bank <name> <driver> <base> <size> <chip_width> <bus_width> <target> [driver_options ...]
  36 set _FLASHNAME $_CHIPNAME.flash
  37 flash bank $_FLASHNAME cfi 0x00000000 0x1000000 2 2 $_TARGETNAME