tcl/board/osk5912.cfg

   1 # http://omap.spectrumdigital.com/osk5912/
   2
   3 source [find target/omap5912.cfg]
   4
   5 # NOTE: this assumes you're using the ARM 20-pin ("Multi-ICE")
   6 # JTAG connector, and accordingly have J1 connecting pins 1 & 2.
   7 # The TI-14 pin needs "trst_only", and J1 connecting 2 & 3.
   8 reset_config trst_and_srst separate
   9
  10 # NOTE:  boards with XOMAP parts wire nSRST to nPWRON_RESET.
  11 # That resets everything -- including JTAG and EmbeddedICE.
  12 # So they must use "reset_config srst_pulls_trst".
  13
  14 # NOTE:  an expansion board could add a trace connector ... if
  15 # it does, change this appropriately.  And reset_config too,
  16 # assuming JTAG_DIS reroutes JTAG to that connector.
  17 etm config $_TARGETNAME 8 demultiplexed full dummy
  18 etm_dummy config $_TARGETNAME
  19
  20 # standard boards populate two 16 MB chips, but manufacturing
  21 # options or an expansion board could change this config.
  22 flash bank cfi 0x00000000 0x01000000 2 2 $_TARGETNAME
  23 flash bank cfi 0x01000000 0x01000000 2 2 $_TARGETNAME
  24
  25 proc osk5912_init {} {
  26         omap5912_reset
  27
  28         # detect flash
  29         flash probe 0
  30         flash probe 1
  31 }
  32 $_TARGETNAME configure -event reset-init { osk5912_init }