tcl/board/str910-eval.cfg

   1 # str910-eval eval board
   2 #
   3 # Need reset scripts
   4 reset_config trst_and_srst
   5
   6 # FIXME use some standard target config, maybe create one from this
   7 #
   8 #       source [find target/...cfg]
   9
  10 if { [info exists CHIPNAME] } {
  11    set  _CHIPNAME $CHIPNAME
  12 } else {
  13    set  _CHIPNAME str912
  14 }
  15
  16 if { [info exists ENDIAN] } {
  17    set  _ENDIAN $ENDIAN
  18 } else {
  19    set  _ENDIAN little
  20 }
  21
  22 if { [info exists FLASHTAPID] } {
  23    set _FLASHTAPID $FLASHTAPID
  24 } else {
  25    set _FLASHTAPID 0x04570041
  26 }
  27 jtag newtap $_CHIPNAME flash -irlen 8 -ircapture 0x1 -irmask 0x1 -expected-id $_FLASHTAPID
  28
  29
  30 if { [info exists CPUTAPID] } {
  31    set _CPUTAPID $CPUTAPID
  32 } else {
  33    set _CPUTAPID 0x25966041
  34 }
  35 jtag newtap $_CHIPNAME cpu   -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
  36
  37 if { [info exists BSTAPID] } {
  38    set _BSTAPID $BSTAPID
  39 } else {
  40    set _BSTAPID 0x1457f041
  41 }
  42 jtag newtap $_CHIPNAME bs    -irlen 5 -ircapture 0x1 -irmask 0x1 -expected-id $_BSTAPID
  43
  44 set _TARGETNAME $_CHIPNAME.cpu
  45 target create $_TARGETNAME arm966e -endian $_ENDIAN -chain-position $_TARGETNAME
  46 $_TARGETNAME configure -work-area-phys 0x50000000 -work-area-size 16384 -work-area-backup 1
  47
  48 $_TARGETNAME configure -event reset-init {
  49         # We can increase speed now that we know the target is halted.
  50         #jtag_rclk 3000
  51
  52         # -- Enable 96K RAM
  53         # PFQBC enabled / DTCM & AHB wait-states disabled
  54         mww 0x5C002034 0x0191
  55
  56         str9x flash_config 0 4 2 0 0x80000
  57         flash protect 0 0 7 off
  58 }
  59
  60 #flash bank str9x <base> <size> 0 0 <target#> <variant>
  61 set _FLASHNAME $_CHIPNAME.flash0
  62 flash bank $_FLASHNAME str9x 0x00000000 0x00080000 0 0 0
  63 set _FLASHNAME $_CHIPNAME.flash1
  64 flash bank $_FLASHNAME str9x 0x00080000 0x00008000 0 0 0