tcl/interface/ftdi/esp32s2_kaluga_v1.cfg

   1 # SPDX-License-Identifier: GPL-2.0-or-later
   2 #
   3 # Driver for the FT2232H JTAG chip on the Espressif Kaluga-1 ESP32-S2 board
   4 # (and most other FT2232H and FT232H based boards)
   5 #
   6 # JTAG DIP switch (labelled SW5 in the schematic) should be "ON" for lines
   7 # labelled TCK, TDO, TDI and TWS, to connect the FT2232H to the ESP32-S2.
   8 #
   9
  10 adapter driver ftdi
  11 ftdi vid_pid 0x0403 0x6010 0x0403 0x6014
  12
  13 # interface 1 is the uart
  14 ftdi channel 0
  15
  16 # TCK, TDI, TDO, TMS: ADBUS0-3
  17 # TRST/SRST: ADBUS5 (unused for now)
  18 # LEDs: ACBUS3-4 (inverted)
  19
  20 ftdi layout_init 0x0008 0x180b
  21 ftdi layout_signal LED -ndata 0x0800
  22 ftdi layout_signal LED2 -ndata 0x1000
  23
  24 # ESP32* series chips do not have a TRST input, and the SRST line is connected
  25 # to the EN pin.
  26 # The target code doesn't handle SRST reset properly yet, so this is
  27 # commented out:
  28 # ftdi layout_signal nSRST -oe 0x0020
  29 # reset_config srst_only