use cortex_a8 instead of cortex_m3

[openocd.git] / tcl / target / omap3530.cfg

# TI OMAP3530
#  http://focus.ti.com/docs/prod/folders/print/omap3530.html
# Other OMAP3 chips remove DSP and/or the OpenGL support

if { [info exists CHIPNAME] } { 
   set  _CHIPNAME $CHIPNAME    
} else {         
   set  _CHIPNAME omap3530
}

# ICEpick-C ... used to route Cortex, DSP, and more not shown here
source [find target/icepick.cfg]

# Subsidiary TAP: C64x+ DSP ... must enable via ICEpick
jtag newtap $_CHIPNAME dsp -irlen 38 -ircapture 0x25 -irmask 0x3f -disable

# Subsidiary TAP: CoreSight Debug Access Port (DAP)
if { [info exists DAP_TAPID ] } {
   set _DAP_TAPID $DAP_TAPID
} else {
   set _DAP_TAPID 0x0b6d602f
}
jtag newtap $_CHIPNAME dap -irlen 4 -ircapture 0x1 -irmask 0xf \
        -expected-id $_DAP_TAPID -disable
jtag configure $_CHIPNAME.dap -event tap-enable \
        "icepick_c_tapenable $_CHIPNAME.jrc 3"

# Primary TAP: ICEpick-C (JTAG route controller) and boundary scan
if { [info exists JRC_TAPID ] } {
   set _JRC_TAPID $JRC_TAPID
} else {
   set _JRC_TAPID 0x0b7ae02f
}
jtag newtap $_CHIPNAME jrc -irlen 6 -ircapture 0x1 -irmask 0x3f \
        -expected-id $_JRC_TAPID

# GDB target:  Cortex-A8, using DAP
target create omap3.cpu cortex_a8 -chain-position $_CHIPNAME.dap

# FIXME much of this should be in reset event handlers
proc omap3_dbginit { } {
     reset
     sleep 500

     jtag tapenable omap3530.dap
     targets
     # sleep 1000
     # dap apsel 1
     # sleep 1000
     # dap apsel 1
     # dap info 1

     # 0xd401.0000 - ETM
     # 0xd401.1000 - Cortex-A8
     # 0xd401.9000 - TPIU (traceport)
     # 0xd401.b000 - ETB
     # 0xd401.d000 - DAPCTL

     omap3.cpu mww 0x54011FB0 0xC5ACCE55

     omap3.cpu mdw 0x54011314
     omap3.cpu mdw 0x54011314
     # omap3.cpu mdw 0x54011080

     omap3.cpu mww 0x5401d030 0x00002000
}