# Product page: # https://www.8devices.com/products/lima # # Location of JTAG pins: # J2 GPIO0 JTAG TCK # J2 GPIO1 JTAG TDI # J2 GPIO2 JTAG TDO # J2 GPIO3 JTAG TMS # J2 RST directly connected to RESET_L of the SoC and can be used as # JTAG SRST. Note: this pin will also reset the debug engine. # J1 +3,3V Can be use as JTAG Vref # J1 or J2 GND Can be used for JTAG GND # # This board is powered from mini USB connecter which is also used # as USB to UART converted based on FTDI FT230XQ chip source [find target/qualcomm_qca4531.cfg] proc board_init { } { qca4531_ddr2_550_550_init } $_TARGETNAME configure -event reset-init { board_init } set ram_boot_address 0xa0000000 $_TARGETNAME configure -work-area-phys 0xa1FFE000 -work-area-size 0x1000 flash bank flash0 ath79 0 0 0 0 $_TARGETNAME cs0