# http://omap.spectrumdigital.com/osk5912/ source [find target/omap5912.cfg] # NOTE: this assumes you're using the ARM 20-pin ("Multi-ICE") # JTAG connector, and accordingly have J1 connecting pins 1 & 2. # The TI-14 pin needs "trst_only", and J1 connecting 2 & 3. reset_config trst_and_srst separate # NOTE: boards with XOMAP parts wire nSRST to nPWRON_RESET. # That resets everything -- including JTAG and EmbeddedICE. # So they must use "reset_config srst_pulls_trst". # NOTE: an expansion board could add a trace connector ... if # it does, change this appropriately. And reset_config too, # assuming JTAG_DIS reroutes JTAG to that connector. etm config $_TARGETNAME 8 demultiplexed full dummy etm_dummy config $_TARGETNAME # standard boards populate two 16 MB chips, but manufacturing # options or an expansion board could change this config. flash bank osk.u1 cfi 0x00000000 0x01000000 2 2 $_TARGETNAME flash bank osk.u2 cfi 0x01000000 0x01000000 2 2 $_TARGETNAME proc osk5912_init {} { omap5912_reset # detect flash flash probe 0 flash probe 1 } $_TARGETNAME configure -event reset-init { osk5912_init } arm7_9 dcc_downloads enable