# Configuration for the ST SPEAr300 Evaluation board # EVALSPEAr300 Rev. 1.0, modified to enable SRST on JTAG connector # http://www.st.com/spear # # List of board modifications to enable SRST, as reported in # ST Application Note (FIXME: add reference). # - Modifications on the top layer: # 1. replace reset chip U4 with a STM6315SDW13F; # - Modifications on the bottom layer: # 2. add 0 ohm resistor R10. It is located close to JTAG connector. # 3. add a 10K ohm pull-up resistor on the reset wire named as # POWERGOOD in the schematic. # # The easier way to do modification 3, is to use a resistor in package # 0603 and solder it between R10 and R54: # - one pad soldered with the pad of R54 connected to 3.3V (this # is the pad of R54 far from JTAG connector J4) # - the other pad soldered with the nearest pad of R10. # # Date: 2011-11-18 # Author: Antonio Borneo # Modified boards has SRST on JTAG connector set BOARD_HAS_SRST 1 source [find board/spear300evb.cfg]