# Configuration for the ST SPEAr310 Evaluation board # EVALSPEAr310 Rev. 2.0, modified to enable SRST on JTAG connector # http://www.st.com/spear # # List of board modifications to enable SRST, as reported in # ST Application Note AN3321. # - Modifications on the top layer: # 1. remove R137 and C57, located near the SMII PHY U18; # 2. remove R172 and C75, located near the SMII PHY U19; # 3. remove R207 and C90, located near the SMII PHY U20; # 4. remove C236, located near the SMII PHY U21; # 5. remove U12, located near the JTAG connector; # 6. solder together pins 7, 8 and 9 of U12; # 7. solder together pins 11, 12, 13, 14, 15, 16, 17 and 18 of U12. # - Modifications on the bottom layer: # 8. replace reset chip U11 with a STM6315SDW13F; # 9. add 0 ohm resistor R329. It is located close to JTAG connector. # # Date: 2009-10-31 # Author: Antonio Borneo # Modified boards has SRST on JTAG connector set BOARD_HAS_SRST 1 source [find board/spear310evb20.cfg]