# # Luminary Micro Stellaris Evaluation Kits # # http://www.luminarymicro.com/products/evaluation_kits.html # # There are a number of evaluation kits for Stellaris Cortex-M3 chips. # Currently they all bundle FT2232 based debug support. When that is # used (instead of an external adapter), use this config file in one # of these two modes: # # - Eval board debug ... debug of the Stellaris chip via port A. # # - Other board debug ... same thing, but the board acts as a debug # adapter for another board (using a standard ARM JTAG connector). # The Stellaris chip stays in reset. # # Those support both JTAG and SWD. SWD is an ARM-only two-wire debug # protocol; in 2009, OpenOCD does not support SWD. # # Port B of the FT2232 chip is normally used as a serial link to the # Stellaris chip. On most boards (but not older LM3S811 eval boards), # when SWD is used Port B may instead be used to read low-bandwidth # "SWO trace" data, including so-called "printf style" output from # firmware via the ITM module as well as profile data. # interface ft2232 ft2232_device_desc "Stellaris Evaluation Board" ft2232_layout luminary_icdi ft2232_vid_pid 0x0403 0xbcd9