# # This file was created using as references the stm32f1x.cfg and aduc702x.cfg # source [find target/swj-dp.tcl] # Chip name if { [info exists CHIPNAME] } { set _CHIPNAME $CHIPNAME } else { set _CHIPNAME aducm360 } # Endianess if { [info exists ENDIAN] } { set _ENDIAN $ENDIAN } else { set _ENDIAN little } # Work-area is a space in RAM used for flash programming # Eventually, the whole SRAM of ADuCM360 will be used (8kB) if { [info exists WORKAREASIZE] } { set _WORKAREASIZE $WORKAREASIZE } else { set _WORKAREASIZE 0x2000 } #jtag scan chain if { [info exists CPUTAPID] } { set _CPUTAPID $CPUTAPID } else { set _CPUTAPID 0x2ba01477 } swd newdap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID # SWD/JTAG speed adapter_khz 1000 ## ## Target configuration ## set _TARGETNAME $_CHIPNAME.cpu target create $_TARGETNAME cortex_m -endian $_ENDIAN -chain-position $_TARGETNAME # allocate the working area $_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size $_WORKAREASIZE -work-area-backup 0 # flash size will be probed set _FLASHNAME $_CHIPNAME.flash flash bank $_FLASHNAME aducm360 0x00 0 0 0 $_TARGETNAME adapter_nsrst_delay 100 cortex_m reset_config sysresetreq