# Atheros AR71xx MIPS 24Kc SoC. # tested on PB44 refererence board adapter_nsrst_delay 100 jtag_ntrst_delay 100 reset_config trst_and_srst set CHIPNAME ar71xx jtag newtap $CHIPNAME cpu -irlen 5 -ircapture 0x1 -irmask 0x1f -expected-id 1 set TARGETNAME $CHIPNAME.cpu target create $TARGETNAME mips_m4k -endian big -chain-position $TARGETNAME $TARGETNAME configure -event reset-halt-post { #setup PLL to lowest common denominator 300/300/150 setting mww 0xb8050000 0x000f40a3 ;# reset val + CPU:3 DDR:3 AHB:0 mww 0xb8050000 0x800f40a3 ;# send to PLL #next command will reset for PLL changes to take effect mww 0xb8050008 3 ;# set reset_switch and clock_switch (resets SoC) } $TARGETNAME configure -event reset-init { #complete pll initialization mww 0xb8050000 0x800f0080 ;# set sw_update bit mww 0xb8050008 0 ;# clear reset_switch bit mww 0xb8050000 0x800f00e8 ;# clr pwrdwn & bypass mww 0xb8050008 1 ;# set clock_switch bit sleep 1 ;# wait for lock # Setup DDR config and flash mapping mww 0xb8000000 0xefbc8cd0 ;# DDR cfg cdl val (rst: 0x5bfc8d0) mww 0xb8000004 0x8e7156a2 ;# DDR cfg2 cdl val (rst: 0x80d106a8) mww 0xb8000010 8 ;# force precharge all banks mww 0xb8000010 1 ;# force EMRS update cycle mww 0xb800000c 0 ;# clr ext. mode register mww 0xb8000010 2 ;# force auto refresh all banks mww 0xb8000010 8 ;# force precharge all banks mww 0xb8000008 0x31 ;# set DDR mode value CAS=3 mww 0xb8000010 1 ;# force EMRS update cycle mww 0xb8000014 0x461b ;# DDR refresh value mww 0xb8000018 0xffff ;# DDR Read Data This Cycle value (16bit: 0xffff) mww 0xb800001c 0x7 ;# delay added to the DQS line (normal = 7) mww 0xb8000020 0 mww 0xb8000024 0 mww 0xb8000028 0 } # setup working area somewhere in RAM $TARGETNAME configure -work-area-phys 0xa0600000 -work-area-size 0x20000 # serial SPI capable flash # flash bank