# SPDX-License-Identifier: GPL-2.0-or-later

# script for GigaDevice gd32e23x Cortex-M23 Series

# https://www.gigadevice.com/microcontroller/gd32e230c8t6/

#
# gd32e23x devices support SWD transports only.
#
source [find target/swj-dp.tcl]
source [find mem_helper.tcl]

if { [info exists CHIPNAME] } {
   set _CHIPNAME $CHIPNAME
} else {
   set _CHIPNAME gd32e23x
}

# Work-area is a space in RAM used for flash programming
# By default use 4kB (as found on some GD32E230s)
if { [info exists WORKAREASIZE] } {
   set _WORKAREASIZE $WORKAREASIZE
} else {
   set _WORKAREASIZE 0x1000
}

# Allow overriding the Flash bank size
if { [info exists FLASH_SIZE] } {
    set _FLASH_SIZE $FLASH_SIZE
} else {
    # autodetect size
    set _FLASH_SIZE 0
}

#jtag scan chain
if { [info exists CPUTAPID] } {
   set _CPUTAPID $CPUTAPID
} else {
   # this is the SW-DP tap id not the jtag tap id
   set _CPUTAPID 0x0bf11477
}

swj_newdap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
dap create $_CHIPNAME.dap -chain-position $_CHIPNAME.cpu

set _TARGETNAME $_CHIPNAME.cpu
target create $_TARGETNAME cortex_m -dap $_CHIPNAME.dap

$_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size $_WORKAREASIZE -work-area-backup 0

# flash size will be probed
set _FLASHNAME $_CHIPNAME.flash
flash bank $_FLASHNAME stm32f1x 0x08000000 $_FLASH_SIZE 0 0 $_TARGETNAME

# SWD speed (may be updated to higher value in board config file)
adapter speed 1000

reset_config srst_nogate

if {![using_hla]} {
    # if srst is not fitted use SYSRESETREQ to
    # perform a soft reset
    cortex_m reset_config sysresetreq
}

$_TARGETNAME configure -event examine-end {
	# Debug clock enable
	# RCU_APB2EN |= DBGMCUEN
	mmw 0x40021018 0x00400000 0

	# Stop watchdog counters during halt
	# DBG_CTL0 |= WWDGT_HOLD | FWDGT_HOLD | STB_HOLD | DSLP_HOLD | SLP_HOLD
	mmw 0x40015804 0x00000307 0
}