#STR730 CPU adapter_khz 3000 if { [info exists CHIPNAME] } { set _CHIPNAME $CHIPNAME } else { set _CHIPNAME str730 } if { [info exists ENDIAN] } { set _ENDIAN $ENDIAN } else { set _ENDIAN little } if { [info exists CPUTAPID] } { set _CPUTAPID $CPUTAPID } else { set _CPUTAPID 0x3f0f0f0f } #use combined on interfaces or targets that can't set TRST/SRST separately reset_config trst_and_srst srst_pulls_trst #jtag scan chain jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0x0f -expected-id $_CPUTAPID #jtag nTRST and nSRST delay adapter_nsrst_delay 500 jtag_ntrst_delay 500 set _TARGETNAME $_CHIPNAME.cpu target create $_TARGETNAME arm7tdmi -endian little -chain-position 0 -variant arm7tdmi $_TARGETNAME configure -event reset-start { adapter_khz 10 } $_TARGETNAME configure -event reset-init { adapter_khz 3000 # Because the hardware cannot be interrogated for the protection state # of sectors, initialize all the sectors to be unprotected. The initial # state is reflected by the driver, too. flash protect 0 0 last off } $_TARGETNAME configure -event gdb-flash-erase-start { flash protect 0 0 7 off } $_TARGETNAME configure -work-area-phys 0xA0000000 -work-area-size 0x4000 -work-area-backup 0 #flash bank set _FLASHNAME $_CHIPNAME.flash flash bank $_FLASHNAME str7x 0x80000000 0x00040000 0 0 $_TARGETNAME STR73x