Most hardware development boards have a UART, a real serial port, or a virtual USB serial device, so this driver
allows you to start building your own JTAG adapter without the complexity of a custom USB connection.
-@deffn {Config Command} {buspirate_port} serial_port
+@deffn {Config Command} {buspirate port} serial_port
Specify the serial port's filename. For example:
@example
-buspirate_port /dev/ttyUSB0
+buspirate port /dev/ttyUSB0
@end example
@end deffn
-@deffn {Config Command} {buspirate_speed} (normal|fast)
+@deffn {Config Command} {buspirate speed} (normal|fast)
Set the communication speed to 115k (normal) or 1M (fast). For example:
@example
-buspirate_mode normal
+buspirate mode normal
@end example
@end deffn
-@deffn {Config Command} {buspirate_mode} (normal|open-drain)
+@deffn {Config Command} {buspirate mode} (normal|open-drain)
Set the Bus Pirate output mode.
@itemize @minus
@item In normal mode (push/pull), do not enable the pull-ups, and do not connect I/O header pin VPU to JTAG VREF.
@end itemize
For example:
@example
-buspirate_mode normal
+buspirate mode normal
@end example
@end deffn
-@deffn {Config Command} {buspirate_pullup} (0|1)
+@deffn {Config Command} {buspirate pullup} (0|1)
Whether to connect (1) or not (0) the I/O header pin VPU (JTAG VREF)
to the pull-up/pull-down resistors on MOSI (JTAG TDI), CLK (JTAG TCK), MISO (JTAG TDO) and CS (JTAG TMS).
For example:
@example
-buspirate_pullup 0
+buspirate pullup 0
@end example
@end deffn
-@deffn {Config Command} {buspirate_vreg} (0|1)
+@deffn {Config Command} {buspirate vreg} (0|1)
Whether to enable (1) or disable (0) the built-in voltage regulator,
which can be used to supply power to a test circuit through
I/O header pins +3V3 and +5V. For example:
@example
-buspirate_vreg 0
+buspirate vreg 0
@end example
@end deffn
-@deffn {Command} {buspirate_led} (0|1)
+@deffn {Command} {buspirate led} (0|1)
Turns the Bus Pirate's LED on (1) or off (0). For example:
@end deffn
@example
-buspirate_led 1
+buspirate led 1
@end example
@end deffn