doc: flash: write_image writes only loadable sections

[openocd.git] / doc / openocd.texi

diff --git a/doc/openocd.texi b/doc/openocd.texi
index 2db8bdd0606925d0226144c268bb09b0ae91f1d8..203a15db40a57c4e9293ab6a2b44c87c77e8b1f2 100644 (file)
--- a/doc/openocd.texi
+++ b/doc/openocd.texi
@@ -2585,6 +2585,11 @@ cmsis_dap_vid_pid 0xc251 0xf001 0x0d28 0x0204
 @end example
 @end deffn
 
+@deffn {Config Command} {cmsis_dap_serial} [serial]
+Specifies the @var{serial} of the CMSIS-DAP device to use.
+If not specified, serial numbers are not considered.
+@end deffn
+
 @deffn {Command} {cmsis-dap info}
 Display various device information, like hardware version, firmware version, current bus status.
 @end deffn
@@ -3100,6 +3105,11 @@ Specifies the adapter layout to use.
 The vendor ID and product ID of the device.
 @end deffn
 
+@deffn {Command} {hla_command} command
+Execute a custom adapter-specific command. The @var{command} string is
+passed as is to the underlying adapter layout handler.
+@end deffn
+
 @deffn {Config Command} {trace} source_clock_hz [output_file_path]
 Enable SWO tracing (if supported). The source clock rate for the
 trace port must be specified, this is typically the CPU clock rate. If
@@ -4834,6 +4844,7 @@ The @var{num} parameter is a value shown by @command{flash banks}.
 
 @deffn Command {flash write_image} [erase] [unlock] filename [offset] [type]
 Write the image @file{filename} to the current target's flash bank(s).
+Only loadable sections from the image are written.
 A relocation @var{offset} may be specified, in which case it is added
 to the base address for each section in the image.
 The file [@var{type}] can be specified