Returns the name of the debug adapter driver being used.
@end deffn
-@deffn Command {adapter usb location} <bus>:<port>[.<port>]...
+@anchor{adapter_usb_location}
+@deffn Command {adapter usb location} <bus>-<port>[.<port>]...
Specifies the physical USB port of the adapter to use. The path
roots at @var{bus} and walks down the physical ports, with each
@var{port} option specifying a deeper level in the bus topology, the last
and are not restricted to containing only decimal digits.)
@end deffn
-@deffn {Config Command} {ftdi_location} <bus>:<port>[,<port>]...
+@deffn {Config Command} {ftdi_location} <bus>-<port>[.<port>]...
+@emph{DEPRECATED -- avoid using this.
+Use the @xref{adapter_usb_location, adapter usb location} command instead.}
+
Specifies the physical USB port of the adapter to use. The path
roots at @var{bus} and walks down the physical ports, with each
@var{port} option specifying a deeper level in the bus topology, the last
All members of the ATSAM D2x, D1x, D0x, ATSAMR, ATSAML and ATSAMC microcontroller
families from Atmel include internal flash and use ARM's Cortex-M0+ core.
-Do not use for ATSAM D51 and E5x: use @xref{atsame5} instead.
+Do not use for ATSAM D51 and E5x: use @xref{atsame5}.
The devices have one flash bank:
flash bank $_FLASHNAME stm32f2x 0 0 0 0 $_TARGETNAME
@end example
+If you use OTP (One-Time Programmable) memory define it as a second bank
+as per the following example.
+@example
+flash bank $_FLASHNAME stm32f2x 0x1FFF7800 0 0 0 $_TARGETNAME
+@end example
+
+@deffn Command {stm32f2x otp } num (@option{enable}|@option{disable}|@option{show})
+Enables or disables OTP write commands for bank @var{num}.
+The @var{num} parameter is a value shown by @command{flash banks}.
+@end deffn
+
Note that some devices have been found that have a flash size register that contains
an invalid value, to workaround this issue you can override the probed value used by
the flash driver.
@option{size} options using DMA.
@end deffn
+@deffn Command {$target_name catch_exc} [@option{off}|@option{sec_el1}|@option{sec_el3}|@option{nsec_el1}|@option{nsec_el2}]+
+Cause @command{$target_name} to halt when an exception is taken. Any combination of
+Secure (sec) EL1/EL3 or Non-Secure (nsec) EL1/EL2 is valid. The target
+@command{$target_name} will halt before taking the exception. In order to resume
+the target, the exception catch must be disabled again with @command{$target_name catch_exc off}.
+Issuing the command without options prints the current configuration.
+@end deffn
+
@section Intel Architecture
Intel Quark X10xx is the first product in the Quark family of SoCs. It is an IA-32