jtag/jlink: switch to command 'adapter serial'

[openocd.git] / doc / openocd.texi

diff --git a/doc/openocd.texi b/doc/openocd.texi
index c36047f07a2d2234024af78b087ecd4d611332e5..58e533f629d3fc14c6b217486263994cedef939d 100644 (file)
--- a/doc/openocd.texi
+++ b/doc/openocd.texi
@@ -2371,9 +2371,9 @@ This command is only available if your libusb1 is at least version 1.0.16.
 Specifies the @var{serial_string} of the adapter to use.
 If this command is not specified, serial strings are not checked.
 Only the following adapter drivers use the serial string from this command:
-cmsis_dap, ft232r, ftdi, kitprog.
+cmsis_dap, ft232r, ftdi, jlink, kitprog, presto, vsllink, xds110.
 The following adapters have their own command to specify the serial string:
-hla, jlink, presto, st-link, vsllink, xds110.
+hla, st-link.
 @end deffn
 
 @section Interface Drivers
@@ -2848,12 +2848,6 @@ to the host. If not specified, USB addresses are not considered. Device
 selection via USB address is not always unambiguous. It is recommended to use
 the serial number instead, if possible.
 
-As a configuration command, it can be used only before 'init'.
-@end deffn
-@deffn {Config Command} {jlink serial} <serial number>
-Set the serial number of the interface, in case more than one adapter is
-connected to the host. If not specified, serial numbers are not considered.
-
 As a configuration command, it can be used only before 'init'.
 @end deffn
 @end deffn
@@ -3010,9 +3004,6 @@ parport cable wiggler
 
 @deffn {Interface Driver} {presto}
 ASIX PRESTO USB JTAG programmer.
-@deffn {Config Command} {presto serial} serial_string
-Configures the USB serial number of the Presto device to use.
-@end deffn
 @end deffn
 
 @deffn {Interface Driver} {rlink}
@@ -3144,11 +3135,6 @@ LaunchPad evaluation boards. The XDS110 is also available as a stand-alone USB
 debug probe with the added capability to supply power to the target board. The
 following commands are supported by the XDS110 driver:
 
-@deffn {Config Command} {xds110 serial} serial_string
-Specifies the serial number of which XDS110 probe to use. Otherwise, the first
-XDS110 found will be used.
-@end deffn
-
 @deffn {Config Command} {xds110 supply} voltage_in_millivolts
 Available only on the XDS110 stand-alone probe. Sets the voltage level of the
 XDS110 power supply. A value of 0 leaves the supply off. Otherwise, the supply