-jtag_nsrst_delay 100
-jtag_ntrst_delay 100
-
-#target configuration
-daemon_startup reset
-
-#target <type> <endianness> <startup mode> <chainpos> <variant>
-target arm926ejs little run_and_halt 0 arm926ejs
-run_and_halt_time 0 500
-@end smallexample
-
-@section Marvell/Intel PXA270 Script
-@cindex Marvell/Intel PXA270 Script
-@smallexample
-# config for Intel PXA270
-# not, as of 2007-06-22, openocd only works with the
-# libftd2xx library from ftdi. libftdi does not work.
-
-telnet_port 3333
-gdb_port 4444
-
-interface ft2232
-ft2232_layout olimex-jtag
-ft2232_vid_pid 0x15BA 0x0003
-ft2232_device_desc "Olimex OpenOCD JTAG"
-jtag_speed 0
-# set jtag_nsrst_delay to the delay introduced by your reset circuit
-# the rest of the needed delays are built into the openocd program
-jtag_nsrst_delay 260
-# set the jtag_ntrst_delay to the delay introduced by a reset circuit
-# the rest of the needed delays are built into the openocd program
-jtag_ntrst_delay 0
-
-#use combined on interfaces or targets that can't set TRST/SRST separately
-reset_config trst_and_srst separate
-
-#jtag scan chain
-#format L IRC IRCM IDCODE (Length, IR Capture, IR Capture Mask, IDCODE)
-jtag_device 7 0x1 0x7f 0x7e
-
-#target configuration
-daemon_startup reset
-
-target xscale little reset_halt 0 pxa27x
-
-# maps to PXA internal RAM. If you are using a PXA255
-# you must initialize SDRAM or leave this option off
-working_area 0 0x5c000000 0x10000 nobackup
-
-run_and_halt_time 0 30
-
-#flash bank <driver> <base> <size> <chip_width> <bus_width>
-# works for P30 flash
-flash bank cfi 0x00000000 0x1000000 2 4 0
-@end smallexample
+@itemize @bullet
+@item @b{load_binary}
+@cindex load_binary
+use @option{load_image} command with same args
+@item @b{dump_binary}
+@cindex dump_binary
+use @option{dump_image} command with same args
+@item @b{flash erase}
+@cindex flash erase
+use @option{flash erase_sector} command with same args
+@item @b{flash write}
+@cindex flash write
+use @option{flash write_bank} command with same args
+@item @b{flash write_binary}
+@cindex flash write_binary
+use @option{flash write_bank} command with same args
+@item @b{arm7_9 fast_writes}
+@cindex arm7_9 fast_writes
+use @option{arm7_9 fast_memory_access} command with same args
+@item @b{flash auto_erase}
+@cindex flash auto_erase
+use @option{flash write_image} command passing @option{erase} as the first parameter.
+@end itemize