@option{--enable-presto_libftdi}
@item
@option{--enable-presto_ftd2xx}
+@item
+@option{--enable-jlink}
@end itemize
If you want to access the parallel port using the PPDEV interface you have to specify
requested. gdb will then know when to set hardware breakpoints, and program flash
using the gdb load command. @option{gdb_flash_program enable} will also need enabling
for flash programming to work.
-Default behaviour is <@var{disable}>
+Default behaviour is <@var{enable}>
@item @b{gdb_flash_program} <@var{enable|disable}>
@cindex gdb_flash_program
Set to <@var{enable}> to cause OpenOCD to program the flash memory when a
@item @b{gw16012}
Gateworks GW16012 JTAG programmer.
@end itemize
+@itemize @minus
+@item @b{jlink}
+Segger jlink usb adapter
+@end itemize
@end itemize
@itemize @bullet
@item wiggler: maximum speed / @var{number}
@item ft2232: 6MHz / (@var{number}+1)
@item amt jtagaccel: 8 / 2**@var{number}
+@item jlink: maximum speed in kHz (0-12000), 0 will use RTCK
@end itemize
Note: Make sure the jtag clock is no more than @math{1/6th × CPU-Clock}. This is
@item @b{target_script} <@var{target#}> <@var{event}> <@var{script_file}>
@cindex target_script
-Event is either @option{reset}, @option{post_halt}, @option{pre_resume} or @option{gdb_program_config}
+Event is one of the following:
+@option{pre_reset}, @option{reset}, @option{post_reset}, @option{post_halt},
+@option{pre_resume} or @option{gdb_program_config}.
+@option{post_reset} and @option{reset} will produce the same results.
-TODO: describe exact semantic of events
@item @b{run_and_halt_time} <@var{target#}> <@var{time_in_ms}>
@cindex run_and_halt_time
The amount of time the debugger should wait after releasing reset before it asserts
mass erase flash memory.
@end itemize
+@subsection Stellaris specific commands
+@cindex Stellaris specific commands
+
+These are flash specific commands when using the Stellaris driver.
+@itemize @bullet
+@item @b{stellaris mass_erase} <@var{num}>
+@cindex stellaris mass_erase
+mass erase flash memory.
+@end itemize
+
@page
@section Architecture Specific Commands
@cindex Architecture Specific Commands