NAND: fix off-by-one error in erase command argument range

[openocd.git] / src / flash / nand / at91sam9.c

diff --git a/src/flash/nand/at91sam9.c b/src/flash/nand/at91sam9.c
index 7cfd763a8b157d350fbe047b8d55c56e2a1f48a6..92ab047f623a3e9972c3dcc79066d3b48c14805a 100644 (file)
--- a/src/flash/nand/at91sam9.c
+++ b/src/flash/nand/at91sam9.c
@@ -414,12 +414,16 @@ static int at91sam9_read_page(struct nand_device *nand, uint32_t page,
                                // attempt recovery
                                uint32_t parity;
 
-                               target_read_u32(target, info->ecc + AT91C_ECCx_PR, &parity);
+                               target_read_u32(target,
+                                               info->ecc + AT91C_ECCx_PR,
+                                               &parity);
                                uint32_t word = (parity & 0x0000FFF0) >> 4;
                                uint32_t bit = parity & 0x0F;
 
                                data[word] ^= (0x1) << bit;
-                               LOG_INFO("Data word %d, bit %d corrected.", word, bit);
+                               LOG_INFO("Data word %d, bit %d corrected.",
+                                               (unsigned) word,
+                                               (unsigned) bit);
                        }
                }
 
@@ -693,28 +697,30 @@ static const struct command_registration at91sam9_sub_command_handlers[] = {
                .handler = handle_at91sam9_cle_command,
                .mode = COMMAND_CONFIG,
                .help = "set command latch enable address line (default is 22)",
-               .usage = "<device_id> <address_line>",
+               .usage = "bank_id address_line",
        },
        {
                .name = "ale",
                .handler = handle_at91sam9_ale_command,
                .mode = COMMAND_CONFIG,
                .help = "set address latch enable address line (default is 21)",
-               .usage = "<device_id> <address_line>",
+               .usage = "bank_id address_line",
        },
        {
                .name = "rdy_busy",
                .handler = handle_at91sam9_rdy_busy_command,
                .mode = COMMAND_CONFIG,
-               .help = "set the input pin connected to RDY/~BUSY signal (no default)",
-               .usage = "<device_id> <base_pioc> <pin_num>",
+               .help = "set the GPIO input pin connected to "
+                       "the RDY/~BUSY signal (no default)",
+               .usage = "bank_id pio_base_addr pin_num",
        },
        {
                .name = "ce",
                .handler = handle_at91sam9_ce_command,
                .mode = COMMAND_CONFIG,
-               .help = "set the output pin connected to chip enable signal (no default)",
-               .usage = "<device_id> <base_pioc> <pin_num>",
+               .help = "set the GPIO output pin connected to "
+                       "the chip enable signal (no default)",
+               .usage = "bank_id pio_base_addr pin_num",
        },
        COMMAND_REGISTRATION_DONE
 };