jtag newtap change & huge manual update

[openocd.git] / src / target / board / eir.cfg

diff --git a/src/target/target/eir-sam7se512.cfg b/src/target/board/eir.cfg
old mode 100644 (file)
new mode 100755 (executable)
similarity index 75%
rename from src/target/target/eir-sam7se512.cfg
rename to src/target/board/eir.cfg
index bf53be1..0876565
--- a/src/target/target/eir-sam7se512.cfg
+++ b/src/target/board/eir.cfg
@@ -1,14 +1,9 @@
-#use combined on interfaces or targets that can't set TRST/SRST separately
-reset_config srst_only srst_pulls_trst
+# Elector Internet Radio board
+# http://www.ethernut.de/en/hardware/eir/index.html
 
-#jtag scan chain
-#format L IRC IRCM IDCODE (Length, IR Capture, IR Capture Mask, IDCODE)
-jtag_device 4 0x1 0xf 0xe
+source [find target/sam7se512.cfg]
 
-target create target0 arm7tdmi -endian little -chain-position 0 -variant arm7tdmi
-
-
-[new_target_name] configure -event reset-init {
+$_TARGETNAME configure -event reset-init {
        # WDT_MR, disable watchdog 
        mww 0xFFFFFD44 0x00008000
 
@@ -97,10 +92,3 @@ target create target0 arm7tdmi -endian little -chain-position 0 -variant arm7tdm
        mww 0xfffffd08 0xa5000001
 }
 
-[new_target_name] configure -work-area-virt 0 -work-area-phys 0x00200000 -work-area-size 0x4000 -work-area-backup 0
-
-#flash bank <driver> <base> <size> <chip_width> <bus_width>
-flash bank at91sam7 0 0 0 0 0
-
-# For more information about the configuration files, take a 
-# look at the "Open On-Chip Debugger (openocd)" documentation.