Use hardware reset and connect under reset on boards with ST-LINK/V2, as

[openocd.git] / tcl / board / hitex_str9-comstick.cfg

diff --git a/tcl/board/hitex_str9-comstick.cfg b/tcl/board/hitex_str9-comstick.cfg
index af7527a1663b83336d550429c0a19f8493b38822..f482fa26ff4c6cd10c96dce55f63f0cb60956be9 100644 (file)
--- a/tcl/board/hitex_str9-comstick.cfg
+++ b/tcl/board/hitex_str9-comstick.cfg
@@ -5,9 +5,9 @@
 source [find interface/hitex_str9-comstick.cfg]
 
 # set jtag speed
-jtag_khz 3000
+adapter_khz 3000
 
-jtag_nsrst_delay 100
+adapter_nsrst_delay 100
 jtag_ntrst_delay 100
 #use combined on interfaces or targets that can't set TRST/SRST separately
 reset_config trst_and_srst
@@ -31,21 +31,21 @@ if { [info exists ENDIAN] } {
    set  _ENDIAN little
 }
 
-if { [info exists FLASHTAPID ] } {
+if { [info exists FLASHTAPID] } {
    set _FLASHTAPID $FLASHTAPID
 } else {
    set _FLASHTAPID 0x04570041
 }
 jtag newtap $_CHIPNAME flash -irlen 8 -ircapture 0x1 -irmask 0x1 -expected-id $_FLASHTAPID
 
-if { [info exists CPUTAPID ] } {
+if { [info exists CPUTAPID] } {
    set _CPUTAPID $CPUTAPID
 } else {
    set _CPUTAPID 0x25966041
 }
 jtag newtap $_CHIPNAME cpu   -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
 
-if { [info exists BSTAPID ] } {
+if { [info exists BSTAPID] } {
    set _BSTAPID $BSTAPID
 } else {
    # Found on STR9-comStick, revision STR912CS-A1
@@ -73,7 +73,7 @@ $_TARGETNAME configure -event reset-init {
 $_TARGETNAME configure -work-area-phys 0x50000000 -work-area-size 16384 -work-area-backup 0
 
 #flash bank <driver> <base> <size> <chip_width> <bus_width>
-set _FLASHNAME $_CHIPNAME.flash
+set _FLASHNAME $_CHIPNAME.flash0
 flash bank $_FLASHNAME str9x 0x00000000 0x00080000 0 0 0
-set _FLASHNAME $_CHIPNAME.flash
+set _FLASHNAME $_CHIPNAME.flash1
 flash bank $_FLASHNAME str9x 0x00080000 0x00008000 0 0 0