Remove annoying end-of-line whitespace from tcl/* files

[openocd.git] / tcl / board / unknown_at91sam9260.cfg

diff --git a/tcl/board/unknown_at91sam9260.cfg b/tcl/board/unknown_at91sam9260.cfg
index 3337eeaa0f01a3183d74f80065d3ffc620e4453e..017f793f31f6468696656aacdbbd7514027df98b 100644 (file)
--- a/tcl/board/unknown_at91sam9260.cfg
+++ b/tcl/board/unknown_at91sam9260.cfg
@@ -1,4 +1,4 @@
-# Thanks to Pieter Conradie for this script! 
+# Thanks to Pieter Conradie for this script!
 #
 # Unknown vendor board contains:
 #
@@ -15,12 +15,12 @@ source [find target/at91sam9260.cfg]
 $_TARGETNAME configure -event reset-start {
         # At reset CPU runs at 22 to 42 kHz.
         # JTAG Frequency must be 6 times slower.
-        jtag_rclk 3                        
+        jtag_rclk 3
         halt
        # RSTC_MR : enable user reset, MMU may be enabled... use physical address
         arm926ejs mww_phys 0xfffffd08 0xa5000501
 }
-       
+
 
 $_TARGETNAME configure -event reset-init {
         mww 0xfffffd44 0x00008000         # WDT_MR : disable watchdog
@@ -37,7 +37,7 @@ $_TARGETNAME configure -event reset-init {
         sleep 10                          # wait 10 ms
 
        # Increase JTAG Speed to 6 MHz if RCLK is not supported
-        jtag_rclk 6000                    
+        jtag_rclk 6000
 
        arm7_9 dcc_downloads enable       # Enable faster DCC downloads
 
@@ -51,7 +51,7 @@ $_TARGETNAME configure -event reset-init {
        mww 0xfffff870 0xffff0000         # PIO_ASR  : Select peripheral function for D15..D31
         mww 0xfffff804 0xffff0000         # PIO_PDR  : Disable PIO function for D15..D31
         mww 0xfffff860 0xffff0000         # PIO_PUDR : Disable D15..D31 pull-ups
-        
+
         mww 0xffffef1c 0x00010102         # EBI_CSA  : Assign EBI Chip Select 1 to SDRAM
                                           #            VDDIOMSEL set for +3V3 memory
                                           #            Disable D0..D15 pull-ups