tcl/interface: universal config for all Raspberry Pi models

[openocd.git] / tcl / interface / raspberrypi2-native.cfg

diff --git a/tcl/interface/raspberrypi2-native.cfg b/tcl/interface/raspberrypi2-native.cfg
index d5edded0f9a4e1b8f039836246ec746965a8ac25..fe9186f239a702e25e7a8b7637b0433c7ad53ed6 100644 (file)
--- a/tcl/interface/raspberrypi2-native.cfg
+++ b/tcl/interface/raspberrypi2-native.cfg
@@ -1,44 +1,6 @@
 # SPDX-License-Identifier: GPL-2.0-or-later
 
-#
-# Config for using Raspberry Pi's expansion header
-#
-# This is best used with a fast enough buffer but also
-# is suitable for direct connection if the target voltage
-# matches RPi's 3.3V and the cable is short enough.
-#
-# Do not forget the GND connection, pin 6 of the expansion header.
-#
+echo "WARNING: interface/raspberrypi2-native.cfg is deprecated."
+echo "WARNING: Please use interface/raspberrypi-native.cfg for all Raspberry Pi models."
 
-adapter driver bcm2835gpio
-
-bcm2835gpio peripheral_base 0x3F000000
-
-# Transition delay calculation: SPEED_COEFF/khz - SPEED_OFFSET
-# These depend on system clock, calibrated for scaling_max_freq 900MHz
-# bcm2835gpio speed SPEED_COEFF SPEED_OFFSET
-bcm2835gpio speed_coeffs 225000 36
-
-# Each of the JTAG lines need a gpio number set: tck tms tdi tdo
-# Header pin numbers: 23 22 19 21
-adapter gpio tck -chip 0 11
-adapter gpio tms -chip 0 25
-adapter gpio tdi -chip 0 10
-adapter gpio tdo -chip 0 9
-
-# Each of the SWD lines need a gpio number set: swclk swdio
-# Header pin numbers: 23 22
-adapter gpio swclk -chip 0 11
-adapter gpio swdio -chip 0 25
-
-# If you define trst or srst, use appropriate reset_config
-# Header pin numbers: TRST - 26, SRST - 18
-
-# adapter gpio trst -chip 0 7
-# reset_config trst_only
-
-# adapter gpio srst -chip 0 24
-# reset_config srst_only srst_push_pull
-
-# or if you have both connected,
-# reset_config trst_and_srst srst_push_pull
+source [find interface/raspberrypi-native.cfg]