drivers/stlink_usb: check error code returned by st-link

[openocd.git] / tcl / target / at91sam7sx.cfg

diff --git a/tcl/target/at91sam7sx.cfg b/tcl/target/at91sam7sx.cfg
index 5cde979de0db9c364ef141fadc859fbeec807786..a563ac0377e2af53dc992afa4e932fba9243fe9a 100644 (file)
--- a/tcl/target/at91sam7sx.cfg
+++ b/tcl/target/at91sam7sx.cfg
@@ -2,18 +2,18 @@
 reset_config srst_only srst_pulls_trst
 
 if { [info exists CHIPNAME] } {
-   set  _CHIPNAME $CHIPNAME
+   set _CHIPNAME $CHIPNAME
 } else {
-   set  _CHIPNAME at91sam7s
+   set _CHIPNAME at91sam7s
 }
 
 if { [info exists ENDIAN] } {
-   set  _ENDIAN $ENDIAN
+   set _ENDIAN $ENDIAN
 } else {
-   set  _ENDIAN little
+   set _ENDIAN little
 }
 
-if { [info exists CPUTAPID ] } {
+if { [info exists CPUTAPID] } {
    set _CPUTAPID $CPUTAPID
 } else {
    set _CPUTAPID 0x3f0f0f0f
@@ -23,7 +23,7 @@ jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CP
 
 set _TARGETNAME $_CHIPNAME.cpu
 
-target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm7tdmi
+target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME
 $_TARGETNAME configure -event reset-init {
         soft_reset_halt
         # RSTC_CR : Reset peripherals
@@ -46,10 +46,8 @@ $_TARGETNAME configure -event reset-init {
        sleep 100
 }
 
-$_TARGETNAME configure -work-area-virt 0 -work-area-phys 0x00200000 -work-area-size 0x4000 -work-area-backup 0
+$_TARGETNAME configure -work-area-phys 0x00200000 -work-area-size 0x4000 -work-area-backup 0
 
 #flash bank <driver> <base_addr> <size> <chip_width> <bus_width> <target_number> [<target_name> <banks> <sectors_per_bank> <pages_per_sector> <page_size> <num_nvmbits> <ext_freq_khz>]
-flash bank at91sam7 0 0 0 0 0 0 0 0 0 0 0 0 18432
-
-# For more information about the configuration files, take a look at:
-# openocd.texi
+set _FLASHNAME $_CHIPNAME.flash
+flash bank $_FLASHNAME at91sam7 0 0 0 0 $_TARGETNAME 0 0 0 0 0 0 0 18432