tcl: replace the deprecated commands with "adapter ..."

[openocd.git] / tcl / target / fm3.cfg

diff --git a/tcl/target/fm3.cfg b/tcl/target/fm3.cfg
index e2d78d1e5563b84e4090c54b7f87daa8864c2e0a..376320e832b3a430f0b7cfb96798d34dd67afbd4 100644 (file)
--- a/tcl/target/fm3.cfg
+++ b/tcl/target/fm3.cfg
@@ -22,18 +22,19 @@ if { [info exists CPUTAPID] } {
 }
 
 # delays on reset lines
-adapter_nsrst_delay 100
+adapter srst delay 100
 if {[using_jtag]} {
    jtag_ntrst_delay 100
 }
 
-# Fujitsu cortex-M3 reset configuration
+# Fujitsu Cortex-M3 reset configuration
 reset_config trst_only
 
 swj_newdap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
+dap create $_CHIPNAME.dap -chain-position $_CHIPNAME.cpu
 
 set _TARGETNAME $_CHIPNAME.cpu
-target create $_TARGETNAME cortex_m -endian $_ENDIAN -chain-position $_TARGETNAME
+target create $_TARGETNAME cortex_m -endian $_ENDIAN -dap $_CHIPNAME.dap
 
 # MB9BF506 has 64kB of SRAM on its main system bus 
 $_TARGETNAME configure -work-area-phys 0x1FFF8000 -work-area-size 0x10000 -work-area-backup 0
@@ -44,7 +45,7 @@ set _FLASHNAME $_CHIPNAME.flash
 flash bank $_FLASHNAME fm3 0 0 0 0 $_TARGETNAME
 
 # 4MHz / 6 = 666kHz, so use 500
-adapter_khz 500
+adapter speed 500
 
 if {![using_hla]} {
    # if srst is not fitted use SYSRESETREQ to