tcl/target: add CC2538 and CC26xx target files (with cJTAG procedure)

[openocd.git] / tcl / target / readme.txt

diff --git a/tcl/target/readme.txt b/tcl/target/readme.txt
index ca23c64bb0214e4f78d0abca029d08302832f2db..f028b11c732325343af0cd41aba00a617282164f 100644 (file)
--- a/tcl/target/readme.txt
+++ b/tcl/target/readme.txt
@@ -1,5 +1,5 @@
 Prerequisites:
-The users of OpenOCD as well as computer programs interacting with OpenOCD are expecting that certain commands 
+The users of OpenOCD as well as computer programs interacting with OpenOCD are expecting that certain commands
 do the same thing across all the targets.
 
 Rules to follow when writing scripts:
@@ -8,30 +8,30 @@ Rules to follow when writing scripts:
        reset
        flash info <bank>
 and
-       reset 
+       reset
        flash erase_address <start> <len>
 and
        reset init
        load
-       
-In most cases this can be accomplished by specifying the default startup mode as reset_init (target command 
+
+In most cases this can be accomplished by specifying the default startup mode as reset_init (target command
 in the configuration file).
- 
-2. If the target is correctly configured, flash must be writable without any other helper commands. It is 
+
+2. If the target is correctly configured, flash must be writable without any other helper commands. It is
 assumed that all write-protect mechanisms should be disabled.
 
 3. The configuration scripts should be defined such as the binary that was written to flash verifies
-(turn off remapping, checksums, etc...) 
+(turn off remapping, checksums, etc...)
 
 flash write_image [file] <parameters>
 verify_image [file] <parameters>
 
-4. jtag_khz sets the maximum speed (or alternatively RCLK). If invoked
+4. adapter_khz sets the maximum speed (or alternatively RCLK). If invoked
 multiple times only the last setting is used.
 
 interface/xxx.cfg files are always executed *before* target/xxx.cfg
-files, so any jtag_khz in interface/xxx.cfg will be overridden by
-target/xxx.cfg. jtag_khz in interface/xxx.cfg would then, effectively,
+files, so any adapter_khz in interface/xxx.cfg will be overridden by
+target/xxx.cfg. adapter_khz in interface/xxx.cfg would then, effectively,
 set the default JTAG speed.
 
 Note that a target/xxx.cfg file can invoke another target/yyy.cfg file,