at91sam7sx.cfg: fix use $_TARGETNAME as target identifier, not '0' warning

[openocd.git] / tcl / target / stm32f2x.cfg

diff --git a/tcl/target/stm32f2x.cfg b/tcl/target/stm32f2x.cfg
index a47b115d22bf9227f9f73df7937060e934b07130..43a944c103d10f646e757fdf8235eb82358fdd45 100644 (file)
--- a/tcl/target/stm32f2x.cfg
+++ b/tcl/target/stm32f2x.cfg
@@ -1,9 +1,9 @@
-# script for stm32f2xxx
+# script for stm32f2x family
 
 if { [info exists CHIPNAME] } {
    set _CHIPNAME $CHIPNAME
 } else {
-   set _CHIPNAME stm32f2xxx
+   set _CHIPNAME stm32f2x
 }
 
 if { [info exists ENDIAN] } {
@@ -26,9 +26,9 @@ if { [info exists WORKAREASIZE] } {
 # bit more to be on the safe side. Perhaps superstition, but if are
 # running off a crystal, we can run closer to the limit. Note
 # that there can be a pretty wide band where things are more or less stable.
-jtag_khz 1000
+adapter_khz 1000
 
-jtag_nsrst_delay 100
+adapter_nsrst_delay 100
 jtag_ntrst_delay 100
 
 #jtag scan chain
@@ -52,10 +52,13 @@ if { [info exists BSTAPID] } {
 jtag newtap $_CHIPNAME bs -irlen 5 -expected-id $_BSTAPID
 
 set _TARGETNAME $_CHIPNAME.cpu
-target create $_TARGETNAME cortex_m3 -endian $_ENDIAN -chain-position $_TARGETNAME
+target create $_TARGETNAME cortex_m -endian $_ENDIAN -chain-position $_TARGETNAME
 
 $_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size $_WORKAREASIZE -work-area-backup 0
 
 set _FLASHNAME $_CHIPNAME.flash
 flash bank $_FLASHNAME stm32f2x 0 0 0 0 $_TARGETNAME
 
+# if srst is not fitted use SYSRESETREQ to
+# perform a soft reset
+cortex_m reset_config sysresetreq