stm32f3x: Allow overriding the flash bank size

[openocd.git] / tcl / target / stm32f3x.cfg

diff --git a/tcl/target/stm32f3x.cfg b/tcl/target/stm32f3x.cfg
index 4ecc7eda3cd1c6fa0caae1000fb7bad884acf602..aa978d9c84fdfa32d5a2effd25a3691c60286711 100644 (file)
--- a/tcl/target/stm32f3x.cfg
+++ b/tcl/target/stm32f3x.cfg
@@ -24,6 +24,14 @@ if { [info exists WORKAREASIZE] } {
    set _WORKAREASIZE 0x4000
 }
 
+# Allow overriding the Flash bank size
+if { [info exists FLASH_SIZE] } {
+   set _FLASH_SIZE $FLASH_SIZE
+} else {
+   # autodetect size
+   set _FLASH_SIZE 0
+}
+
 # JTAG speed should be <= F_CPU/6. F_CPU after reset is 8MHz, so use F_JTAG = 1MHz
 #
 # Since we may be running of an RC oscilator, we crank down the speed a
@@ -63,7 +71,7 @@ target create $_TARGETNAME cortex_m -endian $_ENDIAN -dap $_CHIPNAME.dap
 $_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size $_WORKAREASIZE -work-area-backup 0
 
 set _FLASHNAME $_CHIPNAME.flash
-flash bank $_FLASHNAME stm32f1x 0 0 0 0 $_TARGETNAME
+flash bank $_FLASHNAME stm32f1x 0 $_FLASH_SIZE 0 0 $_TARGETNAME
 
 reset_config srst_nogate