X-Git-Url: https://review.openocd.org/gitweb?p=openocd.git;a=blobdiff_plain;f=NEWS;h=add6c1e9035498574967489daeda9eb5cb3aab56;hp=0b9a6a4a4ed2c1c641a1d6bfa2fe022748b9b0f4;hb=73988aea1f68390cdc60f6b6b777f7a466935084;hpb=3ad171cd537f8fc1bac649f24513ebfafd95baf2

diff --git a/NEWS b/NEWS
index 0b9a6a4a4e..add6c1e903 100644
--- a/NEWS
+++ b/NEWS
@@ -6,21 +6,31 @@ and other issues not mentioned here.
 JTAG Layer:
 	New driver for "Bus Pirate"
 	Rename various commands so they're not JTAG-specific
-	   There are migration procedures for these, but you should
+	   There are migration procedures for most of these, but you should
 	   convert your scripts to the new names, since those procedures
 	   will not be around forever.
+		jtag jinterface ... is now adapter_name
 	   	jtag_khz	... is now adapter_khz
 		jtag_nsrst_delay ... is now adapter_nsrst_delay
 		jtag_nsrst_assert_width ... is now adapter_nsrst_assert_width
+	Support Voipac VPACLink JTAG Adapter.
 
 Boundary Scan:
 
+Transport framework core ... supporting future work for SWD, SPI, and other
+non-JTAG ways to debug targets or program flash.
+
 Target Layer:
+	ARM:
+		- basic semihosting support for ARMv7M.
+		- renamed "armv7m" command prefix as "arm"
 	MIPS:
 		- "ejtag_srst" variant removed. The same functionality is
 		  obtained by using "reset_config none".
 		- added PIC32MX software reset support, this means srst is not
 		  required to be connected anymore.
+	OTHER:
+		- preliminary AVR32 AP7000 support.
 
 Flash Layer:
 	New "stellaris recover" command, implements the procedure
@@ -30,9 +40,18 @@ Flash Layer:
 		re-enabling hardware debugging).
 	PIC32MX now uses algorithm for flash programming, this
 		has increased the performance by approx 96%.
+	New 'pic32mx unlock' cmd to remove readout protection.
+	New STM32 Value Line Support.
+	New 'virtual' flash driver, used to associate other addresses
+		with a flash bank. See pic32mx.cfg for usage.
+	New iMX27 NAND flash controller driver.
 
 Board, Target, and Interface Configuration Scripts:
 	Support IAR LPC1768 kickstart board (by Olimex)
+	Support Voipac PXA270/PXA270M module.
+	New $PARPORTADDR tcl variable used to change default
+		parallel port address used.
+	Remove lm3s811.cfg; use "stellaris.cfg" instead
 
 Core Jim/TCL Scripting:
 	New "add_script_search_dir" command, behaviour is the same