X-Git-Url: https://review.openocd.org/gitweb?p=openocd.git;a=blobdiff_plain;f=doc%2Fopenocd.texi;fp=doc%2Fopenocd.texi;h=6321bf7a640dbb42042cc31d301dac29cdddcd0e;hp=ba495ccd12e94c42cbc33f22d0b4f7e802b238da;hb=b8735bbf7ed7eedb0590edbf2a22929b401887ba;hpb=1f7d58daeef9d695529af0cc41c52095c8936c80

diff --git a/doc/openocd.texi b/doc/openocd.texi
index ba495ccd12..6321bf7a64 100644
--- a/doc/openocd.texi
+++ b/doc/openocd.texi
@@ -10649,6 +10649,16 @@ $_TARGETNAME expose_custom 32=myregister
 @end example
 @end deffn
 
+@deffn {Command} {riscv info}
+Displays some information OpenOCD detected about the target.
+@end deffn
+
+@deffn {Command} {riscv reset_delays} [wait]
+OpenOCD learns how many Run-Test/Idle cycles are required between scans to avoid
+encountering the target being busy. This command resets those learned values
+after `wait` scans. It's only useful for testing OpenOCD itself.
+@end deffn
+
 @deffn {Command} {riscv set_command_timeout_sec} [seconds]
 Set the wall-clock timeout (in seconds) for individual commands. The default
 should work fine for all but the slowest targets (eg. simulators).
@@ -10659,12 +10669,7 @@ Set the maximum time to wait for a hart to come out of reset after reset is
 deasserted.
 @end deffn
 
-@deffn {Command} {riscv set_scratch_ram} none|[address]
-Set the address of 16 bytes of scratch RAM the debugger can use, or 'none'.
-This is used to access 64-bit floating point registers on 32-bit targets.
-@end deffn
-
-@deffn Command {riscv set_mem_access} method1 [method2] [method3]
+@deffn {Command} {riscv set_mem_access} method1 [method2] [method3]
 Specify which RISC-V memory access method(s) shall be used, and in which order
 of priority. At least one method must be specified.