X-Git-Url: https://review.openocd.org/gitweb?p=openocd.git;a=blobdiff_plain;f=tcl%2Ftarget%2Faduc702x.cfg;h=fca0a7f969fb9ddc78d9703d8cd4c2a4764bb0d2;hp=b60c9679bbe11a053e4bdca803e565fd0edfc253;hb=b7d2cdc0d4fc319169c60362708a67e2ff626525;hpb=6881c1b6d686c91a8cd604bdcd6098ab62d4dcb9

diff --git a/tcl/target/aduc702x.cfg b/tcl/target/aduc702x.cfg
index b60c9679bb..fca0a7f969 100644
--- a/tcl/target/aduc702x.cfg
+++ b/tcl/target/aduc702x.cfg
@@ -1,23 +1,23 @@
 if { [info exists CHIPNAME] } {
-   set  _CHIPNAME $CHIPNAME
+   set _CHIPNAME $CHIPNAME
 } else {
-   set  _CHIPNAME aduc702x
+   set _CHIPNAME aduc702x
 }
 
 if { [info exists ENDIAN] } {
-   set  _ENDIAN $ENDIAN
+   set _ENDIAN $ENDIAN
 } else {
-  # This config file was defaulting to big endian..
-   set  _ENDIAN little
+   # This config file was defaulting to big endian..
+   set _ENDIAN little
 }
 
 if { [info exists CPUTAPID] } {
-   set  _CPUTAPID $CPUTAPID
+   set _CPUTAPID $CPUTAPID
 } else {
-   set  _CPUTAPID 0x3f0f0f0f
+   set _CPUTAPID 0x3f0f0f0f
 }
 
-jtag_nsrst_delay 200
+adapter_nsrst_delay 200
 jtag_ntrst_delay 200
 
 ## JTAG scan chain
@@ -35,7 +35,8 @@ $_TARGETNAME configure -work-area-phys 0x10000 -work-area-size 0x2000
 
 ## flash configuration
 # only target number is needed
-flash bank aduc702x 0 0 0 0 0
+set _FLASHNAME $_CHIPNAME.flash
+flash bank $_FLASHNAME aduc702x 0 0 0 0 $_TARGETNAME
 
 ## If you use the watchdog, the following code makes sure that the board
 ## doesn't reboot when halted via JTAG.  Yes, on the older generation
@@ -44,9 +45,9 @@ flash bank aduc702x 0 0 0 0 0
 proc watchdog_service {} {
     global watchdog_hdl
     mww 0xffff036c 0
-#    puts "watchdog!!"
+#    echo "watchdog!!"
     set watchdog_hdl [after 500 watchdog_service]
 }
 
 $_TARGETNAME configure -event reset-halt-post {  watchdog_service }
-$_TARGETNAME configure -event old-pre_resume { global watchdog_hdl; after cancel $watchdog_hdl }
+$_TARGETNAME configure -event resume-start { global watchdog_hdl; after cancel $watchdog_hdl }