X-Git-Url: https://review.openocd.org/gitweb?p=openocd.git;a=blobdiff_plain;f=tcl%2Ftarget%2Famdm37x.cfg;h=c00dae921c49d79054691fede6f4d7450823e4e6;hp=6004070f7b1a96a3994b93c5016fcecc1e01bae3;hb=38030e011542a894237b517c065d22db97525954;hpb=58aecca7b331c203aa79d05987d1e7691cd1617b

diff --git a/tcl/target/amdm37x.cfg b/tcl/target/amdm37x.cfg
index 6004070f7b..c00dae921c 100644
--- a/tcl/target/amdm37x.cfg
+++ b/tcl/target/amdm37x.cfg
@@ -33,7 +33,7 @@ if { [info exists CHIPTYPE] } {
       }
       am35x {
          # Primary TAP: ICEPick-C (JTAG route controller) and boundary scan
-         set _JRC_TAPID "-expected-id 0x0b7ae02f"
+         set _JRC_TAPID "-expected-id 0x0b7ae02f -expected-id 0x0b86802f"
       }
       default {
          error "ERROR: CHIPTYPE was set, but it was not set to a valid value.  Acceptable values are \"dm37x\" or \"am35x\"."
@@ -50,7 +50,7 @@ adapter_khz 10
 ###############################################################################
 # JTAG setup
 # The OpenOCD commands are described in the TAP Declaration section
-#  http://openocd.sourceforge.net/doc/html/TAP-Declaration.html
+#  http://openocd.org/doc/html/TAP-Declaration.html
 ###############################################################################
 
 # The AM/DM37x has an ICEPick module in it like many of TI's other devices. More
@@ -61,7 +61,7 @@ source [find target/icepick.cfg]
 
 # The TAP order should be described from the TDO connection in OpenOCD to the
 #  TDI pin.  The OpenOCD FAQ describes this in more detail:
-#  http://openocd.sourceforge.net/doc/html/FAQ.html
+#  http://openocd.org/doc/html/FAQ.html
 
 # From SPRUGN4R CH27 the available secondary TAPs are in this order from TDO:
 #
@@ -136,7 +136,7 @@ jtag configure $_CHIPNAME.jrc -event setup "jtag tapenable $_CHIPNAME.dap"
 ###############################################################################
 # Target Setup:
 # This section is described in the OpenOCD documentation under CPU Configuration
-#  http://openocd.sourceforge.net/doc/html/CPU-Configuration.html
+#  http://openocd.org/doc/html/CPU-Configuration.html
 ###############################################################################
 
 # Create the CPU target to be used with GDB:  Cortex-A8, using DAP
@@ -199,7 +199,7 @@ $_TARGETNAME configure -event gdb-attach {
 # Run this to enable invasive debugging.  This is run automatically in the
 # reset sequence.
 proc amdm37x_dbginit {target} {
-   # General Cortex A8 debug initialisation
+   # General Cortex-A8 debug initialisation
    cortex_a dbginit
 
    # Enable DBGEN signal.  This signal is described in the ARM v7 TRM, but