X-Git-Url: https://review.openocd.org/gitweb?p=openocd.git;a=blobdiff_plain;f=tcl%2Ftarget%2Fstm32f7x.cfg;h=91ab2891ba48d9d53b57cdab3992ba5c8d5edefe;hp=ba1d12ffb25a98222e8787dfcecc3b6f2a29efe4;hb=78c87f5e81f8b3ee2a72aa546f87985596cb2b9f;hpb=39504a695f759970fea2bcd7036d382fa5eab557

diff --git a/tcl/target/stm32f7x.cfg b/tcl/target/stm32f7x.cfg
old mode 100755
new mode 100644
index ba1d12ffb2..91ab2891ba
--- a/tcl/target/stm32f7x.cfg
+++ b/tcl/target/stm32f7x.cfg
@@ -12,7 +12,7 @@ if { [info exists CHIPNAME] } {
    set _CHIPNAME stm32f7x
 }
 
-   set _ENDIAN little
+set _ENDIAN little
 
 # Work-area is a space in RAM used for flash programming
 # By default use 128kB
@@ -64,10 +64,16 @@ flash bank $_CHIPNAME.otp stm32f2x 0x1ff0f000 0 0 0 $_TARGETNAME
 #     the Flash via ITCM alias as virtual
 flash bank $_CHIPNAME.itcm-flash.alias virtual 0x00200000 0 0 0 $_TARGETNAME $_FLASHNAME
 
+if { [info exists QUADSPI] && $QUADSPI } {
+   set a [llength [flash list]]
+   set _QSPINAME $_CHIPNAME.qspi
+   flash bank $_QSPINAME stmqspi 0x90000000 0 0 0 $_TARGETNAME 0xA0001000
+}
+
 # adapter speed should be <= F_CPU/6. F_CPU after reset is 16MHz, so use F_JTAG = 2MHz
-adapter_khz 2000
+adapter speed 2000
 
-adapter_nsrst_delay 100
+adapter srst delay 100
 if {[using_jtag]} {
  jtag_ntrst_delay 100
 }
@@ -76,7 +82,7 @@ if {[using_jtag]} {
 #
 # This target is compatible with connect_assert_srst, which may be set in a
 # board file.
-reset_config srst_only srst_nogate
+reset_config srst_nogate
 
 if {![using_hla]} {
    # if srst is not fitted use SYSRESETREQ to
@@ -162,12 +168,11 @@ $_TARGETNAME configure -event reset-init {
 	if {[using_jtag]} {
 		[[target current] cget -dap] memaccess 16
 	} {
-		adapter_khz 8000
+		adapter speed 8000
 	}
 }
 
 $_TARGETNAME configure -event reset-start {
 	# Reduce speed since CPU speed will slow down to 16MHz with the reset
-	adapter_khz 2000
+	adapter speed 2000
 }
-