From: Oleksij Rempel <linux@rempel-privat.de>
Date: Mon, 19 Feb 2018 16:00:17 +0000 (+0100)
Subject: tcl/board: add DPTechnics DPT-Board-v1
X-Git-Tag: v0.11.0-rc1~1034
X-Git-Url: https://review.openocd.org/gitweb?p=openocd.git;a=commitdiff_plain;h=c1b8824d1936bd13a3edc11784e3f872ca3255db

tcl/board: add DPTechnics DPT-Board-v1

it is Atheros AR9331 based IoT dev board.

Change-Id: I6fc3cdea1bef49c53045018ff5acfec4d5610ba6
Signed-off-by: Oleksij Rempel <linux@rempel-privat.de>
Reviewed-on: http://openocd.zylin.com/4424
Tested-by: jenkins
Reviewed-by: Paul Fertser <fercerpav@gmail.com>
---

diff --git a/tcl/board/dptechnics_dpt-board-v1.cfg b/tcl/board/dptechnics_dpt-board-v1.cfg
new file mode 100644
index 0000000000..de31c7c090
--- /dev/null
+++ b/tcl/board/dptechnics_dpt-board-v1.cfg
@@ -0,0 +1,32 @@
+# Product page:
+# https://www.dptechnics.com/en/products/dpt-board-v1.html
+#
+# JTAG is a 5 pin array located close to main module in following order:
+# 1. JTAG TCK
+# 2. JTAG TDO
+# 3. JTAG TDI
+# 4. JTAG TMS
+# 5. GND	The GND is located near letter G of word JTAG on board.
+#
+# Two RST pins are connected to:
+# 1. GND
+# 2. GPIO11	this pin is located near letter R of word RST.
+#
+# To enable EJTAG mode, GPIO11 (RST[1]) pin should be pulled up. For example
+# with 10K resistor connected to V3.3 pin.
+#
+# This board is powered from micro USB connector. No real reset pin or button, for
+# example RESET_L is available.
+
+source [find target/atheros_ar9331.cfg]
+
+$_TARGETNAME configure -event reset-init {
+	ar9331_25mhz_pll_init
+	sleep 1
+	ar9331_ddr2_init
+}
+
+set ram_boot_address 0xa0000000
+$_TARGETNAME configure -work-area-phys 0xa1FFE000 -work-area-size 0x1000
+
+flash bank flash0 ath79 0 0 0 0 $_TARGETNAME cs0