From 103c1f9525436892b610b37d5efc4f2635f5a832 Mon Sep 17 00:00:00 2001 From: Mike Dunn Date: Sun, 19 Sep 2010 15:30:59 -0700 Subject: [PATCH] xscale: some wp detail added to user manual MIME-Version: 1.0 Content-Type: text/plain; charset=utf8 Content-Transfer-Encoding: 8bit Hi everyone (again), Watchpoints on xscale are quirky, so I thought a little explanation in the user's manual was warranted. Comments gratefully received. Last one, Øyvind :-) Thanks, Mike Signed-off-by: Mike Dunn --- doc/openocd.texi | 9 +++++++++ 1 file changed, 9 insertions(+) diff --git a/doc/openocd.texi b/doc/openocd.texi index bc026b90c7..230e47c9e4 100644 --- a/doc/openocd.texi +++ b/doc/openocd.texi @@ -6390,6 +6390,15 @@ the @code{xscale debug_handler} command. The allowed locations for the debug handler are either (0x800 - 0x1fef800) or (0xfe000800 - 0xfffff800). The default value is 0xfe000800. +XScale has resources to support two hardware breakpoints and two +watchpoints. However, the following restrictions on watchpoint +functionality apply: (1) the value and mask arguments to the @code{wp} +command are not supported, (2) the watchpoint length must be a +power of two and not less than four, and can not be greater than the +watchpoint address, and (3) a watchpoint with a length greater than +four consumes all the watchpoint hardware resources. This means that +at any one time, you can have enabled either two watchpoints with a +length of four, or one watchpoint with a length greater than four. These commands are available to XScale based CPUs, which are implementations of the ARMv5TE architecture. -- 2.30.2