tcl/target/stm32(f7/h7)x: do not assume presence of the reset

[openocd.git] / tcl / board / embedded-artists_lpc2478-32.cfg

diff --git a/tcl/board/embedded-artists_lpc2478-32.cfg b/tcl/board/embedded-artists_lpc2478-32.cfg
index 8ef9179de18c12b0096921d746bc77456fd35a99..38f5e1b8eb3d1077c39e7d6aabd58eda8c9aa6ea 100644 (file)
--- a/tcl/board/embedded-artists_lpc2478-32.cfg
+++ b/tcl/board/embedded-artists_lpc2478-32.cfg
@@ -26,7 +26,7 @@ proc init_board {} {
     global _CHIPNAME
 
     # A working area will help speeding the flash programming
-    $_TARGETNAME configure -work-area-phys 0x40000200 -work-area-size [expr 0x10000-0x200-0x20] -work-area-backup 0
+    $_TARGETNAME configure -work-area-phys 0x40000200 -work-area-size [expr {0x10000-0x200-0x20}] -work-area-backup 0
 
     # External 16-bit flash at chip select CS0 (SST39VF3201-70, 4 MiB)
     flash bank $_CHIPNAME.extflash cfi 0x80000000 0x400000 2 2 $_TARGETNAME jedec_probe
@@ -125,7 +125,7 @@ proc init_board {} {
 #
 proc enable_pll {} {
     # Disconnect PLL in case it is already connected
-    if {[expr [read_register 0xE01FC080] & 0x03] == 3} {
+    if {[expr {[read_register 0xE01FC080] & 0x03}] == 3} {
         # Disconnect it, but leave it enabled
         # (This MUST be done in two steps)
         mww 0xE01FC080 0x00000001       ;# PLLCON: disconnect PLL