-# Since we may be running of an RC oscilator, we crank down the speed a
-# bit more to be on the safe side. Perhaps superstition, but if are
-# running off a crystal, we can run closer to the limit. Note
-# that there can be a pretty wide band where things are more or less stable.
+# dsu_reset_deassert configures whether we want to run or halt out of reset,
+# then instruct the DSU to let us out of reset.
+$_TARGETNAME configure -event reset-deassert-post {
+ at91samd dsu_reset_deassert
+}
+
+# SRST (wired to RESET_N) resets debug circuitry
+# srst_pulls_trst is not configured here to avoid an error raised in reset halt
+reset_config srst_gates_jtag
+
+# Atmel's EDBG (on-board cmsis-dap adapter of Xplained kits) cannot
+# stop the MCU before it starts executing code if hardware RESETN
+# line is configured by command "reset_config srst_only"
+# Use "reset_config none" (default) before flash programming.
+
+# Do not use a reset button with other SWD adapter than Atmel's EDBG.
+# DSU usually locks MCU in reset state until you issue a reset command
+# in OpenOCD.
+
+# SAMD runs at SYSCLK = 1 MHz divided from RC oscillator after reset.
+# Other members of family usually use SYSCLK = 4 MHz after reset.
+# Datasheet does not specify SYSCLK to SWD clock ratio.
+# Usually used SYSCLK/6 is slow, testing shows that debugging can
+# work @ SYSCLK/2 but your mileage may vary.
+# This limit is most probably imposed by incorrectly handled SWD WAIT
+# on some SWD adapters.
+
+adapter_khz 400