target: add Espressif ESP32-S2 basic support

[openocd.git] / tcl / target / stm32f7x.cfg

diff --git a/tcl/target/stm32f7x.cfg b/tcl/target/stm32f7x.cfg
index 6ad4b65f8f568dd5b07063b9842000a67456d54a..91ab2891ba48d9d53b57cdab3992ba5c8d5edefe 100644 (file)
--- a/tcl/target/stm32f7x.cfg
+++ b/tcl/target/stm32f7x.cfg
@@ -12,7 +12,7 @@ if { [info exists CHIPNAME] } {
    set _CHIPNAME stm32f7x
 }
 
-   set _ENDIAN little
+set _ENDIAN little
 
 # Work-area is a space in RAM used for flash programming
 # By default use 128kB
@@ -64,6 +64,12 @@ flash bank $_CHIPNAME.otp stm32f2x 0x1ff0f000 0 0 0 $_TARGETNAME
 #     the Flash via ITCM alias as virtual
 flash bank $_CHIPNAME.itcm-flash.alias virtual 0x00200000 0 0 0 $_TARGETNAME $_FLASHNAME
 
+if { [info exists QUADSPI] && $QUADSPI } {
+   set a [llength [flash list]]
+   set _QSPINAME $_CHIPNAME.qspi
+   flash bank $_QSPINAME stmqspi 0x90000000 0 0 0 $_TARGETNAME 0xA0001000
+}
+
 # adapter speed should be <= F_CPU/6. F_CPU after reset is 16MHz, so use F_JTAG = 2MHz
 adapter speed 2000
 
@@ -76,7 +82,7 @@ if {[using_jtag]} {
 #
 # This target is compatible with connect_assert_srst, which may be set in a
 # board file.
-reset_config srst_only srst_nogate
+reset_config srst_nogate
 
 if {![using_hla]} {
    # if srst is not fitted use SYSRESETREQ to